SN74HCT374PWR

SN74HCT374PWR Overview

It is embeded in 20-TSSOP (0.173, 4.40mm Width) case. The Tape & Reel (TR)package contains it. The output it is configured with uses Tri-State, Non-Inverted. In the configuration of the trigger, Positive Edgeis used. Surface Mountmounts this electrical part. The supply voltage is set to 4.5V~5.5V. It is operating at a temperature of -40°C~85°C TA. This electronic flip flop is of type D-Type. This type of FPGA is a part of the 74HCT series. You should not exceed 40MHzin the output frequency of the device. The list contains 1 elements. 20terminations have occurred. It is a member of the 74HCT374 family. It is powered from a supply voltage of 5V. The input capacitance of this JK flip flopis 3pF farads. In this case, the D flip flop belongs to the HCTfamily. There is an electronic part mounted in the way of Surface Mount. It is designed with 20 pins. This device exhibits a clock edge trigger type of Positive Edge. It is included in FF/Latches. It is designed with a number of bits of 8. Despite its superior flexibility, it relies on 8 circuits to achieve it. Considering its reliability, this T flip flop is well suited for TR. It runs on 5Vvolts of power. There are 2 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. If high efficiency is desired, the supply voltage should be kept at 5V. There are 3 input Lines, which consist of an electronic circuit connected between the ac mains and the rectifier input stage of the switching power supply. There is 8μA quiescent current consumption by it.

SN74HCT374PWR Features

Tape & Reel (TR) package
74HCT series
20 pins
8 Bits
5V power supplies

SN74HCT374PWR Applications

There are a lot of Texas Instruments SN74HCT374PWR Flip Flops applications.

• Storage Registers
• Automotive
• Memory
• Frequency Dividers
• Data transfer
• Buffered Clock
• EMI reduction circuitry
• Bus hold
• ESD protection
• High Performance Logic for test systems