SN74AHC374NSR

SN74AHC374NSR Overview

The package is in the form of 20-SOIC (0.209, 5.30mm Width). It is contained within the Tape & Reel (TR)package. This output is configured with Tri-State, Non-Inverted. The trigger configured with it uses Positive Edge. There is an electrical part that is mounted in the way of Surface Mount. A voltage of 2V~5.5Vis required for its operation. In this case, the operating temperature is -40°C~85°C TA. This logic flip flop is classified as type D-Type. In terms of FPGAs, it belongs to the 74AHC series. A frequency of 120MHzshould not be exceeded by its output. In total, there are 1 elements. As a result, it consumes 4μA quiescent current. Currently, there are 20 terminations. This D latch belongs to the family of 74AHC374. A voltage of 3.3V is used to power it. There is 4pF input capacitance for this T flip flop. In this case, the D flip flop belongs to the AHC/VHC/H/U/Vfamily. There is an electronic component mounted in the way of Surface Mount. There are 20pins on it. Its clock edge trigger type is Positive Edge. The RS flip flops belongs to FF/Latches base part number. The design is based on 8bits. It reaches the maximum supply voltage (Vsup) at 5.5V. Normally, the supply voltage (Vsup) should be above 2V. Despite its superior flexibility, it relies on 8 circuits to achieve it. As a result of its reliable performance, this T flip flop is suitable for TR. The system runs on a power supply of 2/5.5V watts. The flip flop contains 2ports. As a result of its output current of 8mA, it is very flexible in terms of design. The number of input lines is 3.

SN74AHC374NSR Features

Tape & Reel (TR) package
74AHC series
20 pins
8 Bits
2/5.5V power supplies

SN74AHC374NSR Applications

There are a lot of Texas Instruments SN74AHC374NSR Flip Flops applications.

• Cold spare funcion
• Supports Live Insertion
• Functionally equivalent to the MC10/100EL29
• Latch-up performance
• Registers
• Computing
• Clock pulse
• Frequency division
• Latch
• Count Modes