MM74HC273MTC

MM74HC273MTC Overview

It is embeded in 20-TSSOP (0.173, 4.40mm Width) case. You can find it in the Tubepackage. The output it is configured with uses Non-Inverted. It is configured with a trigger that uses Positive Edge. There is an electrical part that is mounted in the way of Surface Mount. It operates with a supply voltage of 2V~6V. It is operating at -40°C~85°C TA. D-Typedescribes this flip flop. In this case, it is a type of FPGA belonging to the 74HC series. In order for it to function properly, its output frequency should not exceed 78MHz. The element count is 1 . There is 8μA quiescent consumption. There are 20 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. The object belongs to the 74HC273 family. An input voltage of 4.5Vpowers the D latch. A JK flip flop with a 7pFfarad input capacitance is used here. HC/UHis the family of this D flip flop. In this case, the electronic component is mounted in the way of Surface Mount. Basically, it is designed with a set of 20 pins. This device has Positive Edgeas its clock edge trigger type. It is part of the FF/Latchesbase part number family. An electronic part designed with 8bits is used in this application. As soon as Vsup reaches 6V, the maximum supply voltage is reached. For normal operation, the supply voltage (Vsup) should be kept above 2V. The D latch runs on a voltage of 2/6V volts. 8is the number of channels.

MM74HC273MTC Features

Tube package
74HC series
20 pins
8 Bits
2/6V power supplies

MM74HC273MTC Applications

There are a lot of ON Semiconductor MM74HC273MTC Flip Flops applications.

• ESD performance
• Latch
• Modulo – n – counter
• Balanced Propagation Delays
• Load Control
• Cold spare funcion
• Single Down Count-Control Line
• High Performance Logic for test systems
• Bounce elimination switch
• Circuit Design